#!/bin/sh
# network-xen-multi-bridge
# Exit if anything goes wrong.
set -e
# First arg is the operation.
OP=$1
shift
script=/etc/xen/scripts/network-bridge.xen
case ${OP} in
start)
        $script start vifnum=0 bridge=xenbr0 netdev=eth0
        $script start vifnum=1 bridge=xenbrbond1 netdev=bond1
        $script start vifnum=2 bridge=xenbr2 netdev=eth2
        $script start vifnum=3 bridge=xenbrbond2 netdev=bond2

        ;;
stop)
        $script stop vifnum=0 bridge=xenbr0 netdev=eth0
        $script stop vifnum=1 bridge=xenbrbond1 netdev=bond1
        $script stop vifnum=2 bridge=xenbr2 netdev=eth2
        $script stop vifnum=3 bridge=xenbrbond2 netdev=bond2
        ;;
status)
        $script status vifnum=0 bridge=xenbr0 netdev=eth0
        $script status vifnum=1 bridge=xenbrbond1 netdev=bond1
        $script status vifnum=2 bridge=xenbr2 netdev=eth2
        $script status vifnum=3 bridge=xenbrbond2 netdev=bond2
        ;;
*)
        echo 'Unknown command: ' ${OP}
        echo 'Valid commands are: start, stop, status'
        exit 1
esac

(network-script network-multibridge)
(network-script network)